Description
Features
- Constructed of food grade plastic, sealing rubber
- Keg fitting thread: Diameter 33.5mm, screw pitch 1.5mm, fit with mini keg series (64oz, one gallon, 5 liter, 10 liter)
- Safety pressure: 30PSI
- Gas-in: Brass fitting with thread of M8*0.75
- Beer-out: Silicone beer hose and plastic beer faucet
Shopping Guide
From first beginning, SinoBatoo R&D team focus on draft beer dispensing system, till now, we presented more than 20 types of spear, allow people to tap draft beer/ cold brew coffee at home or outdoor gathering.
As introduced, most of our beer spear made of stainless steel 304, we also have few types of plastic spear, design for mini keg or glass growler.
Unit Operation Instructions:
- Like any beer container, do not shake the keg beer before use. Give it time to settle after bringing it home from the brewery.
- Remove keg cap and replace with plastic spear, install plastic beer faucet and CO2 regulator with capsule.
- Too much pressure would cause over foam. Since keg beer coming with own pressure, we suggest first tapping without CO2 injection.
- Open the faucet over your beer glass and lightly turn on knob of CO2 regulator. Start with 2~3 PSI and lightly increase to 4~5 PSI (max 8~10PSI) to achieve perfect pouring.
- If too much foam due to over pressure, pull on the pressure relieving ring for couple of seconds will help to release over pressure.
- Turn off the regulator knob when you finish tapping. The remain gas would keep beer fresh for days, but don’t forget to put whole system into refrigerator.
- If you are using CO2 charger without gauge, after dispensing beer, close the faucet and again press the button on the CO2 briefly to maintain internal CO2 pressure. Failure to recharge after dispensing will lead to flat beer.
- Dispensing the last glass of beer through the faucet uses more CO2 than dispensing all the previous beer.
Clean and Care Instructions:
- After each keg is finished, remove CO2 regulator. Never put CO2 regulator into water.
- Hand wash with warm soapy water to clean your beer spear. Open the faucet and allow water to flow through the hoses. Rinse with cold water. Keep the faucet open to allow water to drain out and air dry.
- Do not use decolorize, which will destroy mini keg and spear.
- Do not microwave.
- Not designed for hot liquids, nonfood, or caustic, highly acidic materials.
- Keep whole system, especially silicone seal away from kids.
- Use under suggested pressure for safety.
